Filter
Top Products
C H A P T E R 3
Usingyour interactive whiteboardsystem
19 smarttech.com/kb/170510
Setting Use Notes
Set to Default? Resets projector settings to
their default values.
If you select Yes, all projector settings reset to
their defaults, reversing any menu changes
you made. This action is irreversible.
Don’t adjust this setting unless you want to
reset all of the applied settings, or unless
you’re advised to by a SMARTSupport
specialist.
USB Source
Select
Opens asub-menu that enables
you to select the video input on
your projector and the USB
receptacle on the ECP.
The defaults are:
l
HDMI -1, USB 1
l
HDMI -2, Disabled (no associated USB
input)
l
VGA - 1, USB 2
Network menu
Network Activates the projector’s RJ45
connector and network features.
Status Displays the current network
status (Connected,
Disconnected or Off).
The default is off.
DHCP Displays the status of the
network’s Dynamic Host
Configuration Protocol (DHCP)
as On or Off.
The default is on.
On enables a DHCP server on the network to
automatically assign an IP address to the
projector.
Off enables an administrator to assign an IP
address manually.
Password
Reminder
E-mails the network password
to the predefined e-mail
recipient.
See Web page management on page 47 to set
up a destination e-mail address.
IP Address Displays the projector’s current
IP address in values between
0.0.0.0 and 255.255.255.255.
To change the projector’s IP address, use the
RS-232 connector (see Network controls on
page 68) or use a DHCP server to assign a
dynamic IP address, and then set astatic IP
address using the network remote
management feature (see Remotely managing
your system through a network interface on
page 47).
Subnet Mask Displays the projector’s subnet
mask number in values between
0.0.0.0 and 255.255.255.255.