Filter
Top Products
A P P E N D I X B
Remotelymanagingyour systemthrough anRS-232serialinterface
68 smarttech.com/kb/170510
Network controls
These commands control the integration properties of the projector.
Usable Command
by Power State
Property Valid Values Notes
Standby
/ Idle
On
set or get network
• on
• off (default)
Enables or disables the
network module,
set or get set or get vgaoutnetenable
• on
• off (default)
Same function as the ‘network’
property.
get get netstatus
• connected
• disconnected
• disabled
Reports if the network port on
the projector is or is not
connected to a network.
set or get set or get dhcp
• on
• off (default)
When off, the projector's
network IP address,
subnetmask, gateway, and
primary dns values must all be
set manually.
set or get set or get ipaddr [0~255].[0~255].[0~255].
[0~255] [a valid IPv4
address]
An IPv4 address.
set or get set or get subnetmask [0~255].[0~255].[0~255].
[0~255] [a valid IPv4
address]
An IPv4 address..
set or get set or get gateway [0~255].[0~255].[0~255].
[0~255] [a valid IPv4
address]
An IPv4 address..
set or get set or get primarydns [0~255].[0~255].[0~255].
[0~255] [a valid IPv4
address]
An IPv4 address.
get set or get macaddr [00~FF]-[00~FF]-[00~FF]-
[00~FF]-[00~FF]-[00~FF]
The media access control
(MAC) identifier of the
projector’s network module.