Filter
Top Products
A P P E N D I X B
Remotelymanagingyour systemthrough anRS-232serialinterface
60 smarttech.com/kb/170510
Command Control basics
off now Commands the projector to immediately stop projecting an image, cool down the
projector lamp, and enter the standby / idle power state without requiring any
further confirmation.
get [parameter] Commands the projector to allow you to retrieve information from the projector,
about the current state of one of the projector’s operating parameters.
set [parameter]
= [value]
Commands the projector to allow you to change the current state of one of the
projector’s operating parameters. For values which are numeric, the ‘set’
command can also use a plus “+” or a minus “-“operator, in addition to an equals
“=” operator.
N OT E S
1.
1. Attempts to set aparameter to an invalid value will return an ‘invalid
command’ response.
2. For parameters which use numeric values, attempts to set the value
outside of its operating range will simply result in setting the parameter to
its maximum or minimum value.
Projector operating parameters which are accessible via the ‘set’ or ‘get’ commands are listed in
reference tables in the following sections.
N OT E
Sending the projector an invalid command will result in an “invalidcmd=[the command sent]”
message from the projector.