Filter
Top Products
A P P E N D I X B
Remotelymanagingyour systemthrough anRS-232serialinterface
59 smarttech.com/kb/170510
3. Configure your serial interface settings using the values in the previous table, and then press
ENTER.
The > character appears as acommand prompt.
N OT E
If no message or an error message appears, your serial interface configuration isn’t correct.
Repeat step 3.
4. Type commands to configure your settings.
N OT E S
o
To see alist of commands available in the current operating mode, type ? and then press
ENTER.
o
If you’re using a terminal emulation program, turn on your program’s local echo setting to
see characters as you type them.
Projector programming commands
This section documents the projector programming commands.
Projector power state controls
Your projector responds to commands only at certain power states and times.
There are six projector power states:
Command Control basics
? Commands the projector to output a list of commands which are available in the
projector’s current operating mode. Note that some commands which are actually
available may not appear in the resulting list.
on Commands the projector to exit from standby, ignite the lamp, and begin
projecting an image.
off Commands the projector to stop projecting an image, cool down the projector
lamp, and enter the standby / idle power state. The projector will not do this
immediately, instead it will reply with a request for confirmation, which must be
followed by a second ‘off’ command within 10 seconds.