Filter
Top Products
A P P E N D I X B
Remotelymanagingyour systemthrough anRS-232serialinterface
67 smarttech.com/kb/170510
Usable Command
by Power State
Property Valid Values Notes
Standby /
Idle
On
get resolution last known video input
resolution in the format of
###x###@##Hz or ###i/p
set or get highspeedfan
• high
• normal (default)
Enable the high speed fan in
hot environments, to prevent
overheating.
get get failurelog Returns a text list of
failures detected by the
projector, and logged in
the projector's failure log
(or an indication of
'normal'). This will be in
the format of failure1,
failure2, failure3, etc.
Failures detectable by the
projector include the
following: •overtemp • fanlock
• fanDMD • fanblower •
fansystem • lamperror •
colorwheelbreak • lampignite
• lampoverheat • lampdriver •
lampoverhours
get gett error# Returns text information
about the specified error
number in the projector’s
error log.•
Reported data: Error type,
lamp hours, system hours,
system temperature, and
lamp voltage when the error
was detected.
set set restoredefaults <no values – immediate
action>
This will reset the projector
operating parameters to their
factory default settings. A
hard power-cycle may be
required to complete.
set set factoryreset
• true
• false
Setting this to ‘true’ will reset
the projector operating
parameters to their factory
default settings. A hard
power-cycle may be required
to complete.