Filter
Top Products
C H A P T E R 4
Maintainingyour interactive whiteboardsystem
27 smarttech.com/kb/170510
Cleaning the projector
W A R N I N G
Cleaning a wall-mounted projector can result in a fall or injury. Use caution when climbing a ladder.
C A U T I O N
l
Before you clean the projector, press the Power button twice on the ECP or remote control
to put the system in Standby mode, and then wait 30 minutes for the lamp to cool completely.
l Never touch the lens or the mirror with your hands or a brush.
l Do not allow liquids or commercial solvents of any kind to flow into the projector base or head.
Do not spray cleaners or solvents near any part of the projector because they can spread a
chemical mist on some of the projector’s components and lamp, resulting in damage, staining
or poor image quality.
l Do not use compressed air to clean the projector.
When cleaning the projector’s lens or mirror:
l Use a bellows bulb or air blower bulb (commonly found in audio-visual supply stores) to blow off
dust.
l If wiping the lens or mirror is unavoidable, wear protective gloves and gather the cleaning cloth
into a ball. Gently fan the cleaning cloth across the lens or mirror like you would a feather duster.
Do not apply any pressure to the lens or mirror.
Focusing and adjusting the projector image
For information on focusing and adjusting the projector image, see Setting up the projector image on
page 9.
Removing and replacing the projector lamp
module
Eventually the lamp module will dim, and a message will appear reminding you to replace the lamp.
Make sure you have a replacement projector lamp module before proceeding.
For instructions on how to replace the projector lamp module, go to smarttech.com/kb/170389.