Filter
Top Products
Connecting the interface cable
Connect the printer to your computer using a standard Centronics parallel
interface cable. On a PS/2 or PC/AT-type computer, this means that you use
the25-pin D-typeconnector at thecomputerend, and theAmphenol-type 36-
pin connector at the printerend. The configuration ofthe printer’s connector
is given in Chapter 11 should you need a cable for connecting to another
computer.
If you need to connect to a serial port, use the optional Serial-Parallel
Corwerter, SPC-8K.
Follow the procedures below to connect the interface cable:
1. Turn off the power switch both the printer and the computer.
2. Connect the interface cable to the printer as shown in Figure 2
Make sure that you press the plug into the interface connector.
12.
~/ y
/
Interface connector
\
\ /’”’”
$
* \/
ti-
\
Interfacecable
“\
Figure 2-12. Connecting the interface cable
3. Move both clips inside the extended prongs on the sidesof the plug until
you hear a click.
/
\,/
&“””””
.,
$
‘
4
&
/
y
‘\
-1
Figure 2-73. Move the clips until you hear a click
4. Connect the other end of the interface cable to your computer. Use your
computer instructions to attach the interface cable.
17