Filter
Top Products
SWITCH COMBINATION FUNCTIONS
Several additional functions can be achieved by pressing the control panel
buttons in combinations.
Top of form
m
~~
~ .“’cRO’””-
= POWER
8
L----J ‘“NT““”
‘J’’T’’’:KpE;EEDyO
1 n 7 1 m
. — -
—CCL–2
-.
Em. m.. SWITCH SE, ,,,!4,
1-
-
‘x”
Save macru
Form
feed
Bufferclear/All reset
I
If you are using cut forms, this operation ejects the current page. If you are
using fanfold forms, it feeds to the top of the next page.
1.
2.
3.
Press the 1
ON LINE
1
button to set the printer off-line.
Press the \
PAPERFEED] button and hold it down. The printer will start
performing successive line feeds.
While holding the I
PAPERFEED] button down, press the I ON LINE
1
button, then release both buttons at the same time. The printer will
smoothly eject the current page.
Top of form
When you power on theprinter, thetop-of-form position is automatically set
to the current position.If this is not where you want the top of the page to be,
you can change the top-of-form position as follows:
1. Press the [
ON LINE
]
button to set the printer off-line.
2. Move the paper to the desired top-of-form position by pressing the
I
PAPERFEEDIbutton, or by performing a forward or reverse micro-feed.
3. Press and hold the [
ON LINE
]
button.
4. While holding the 1
ON LINE
]
button down, press the E133Xilbutton,
then release both buttons at the same time. The ‘-––”message will show
on the LCD display, that the top-of-form position has been set.
41