Filter
Top Products
PULL TRACTOR UNIT (PT-IOZS)
You can use the Pull Tractor Unit to print on fanfold forms or multi-part
forms through the bottom feed slot.
Setting up
The procedure to mount the Pull Tractor Unit is:
1.
2.
3.
4.
Open the front cover by lifting up the back using the two grips on either
side, then remove it.
Open the rear cover by lifting up the front using the two grips on either
side.
Move the printer bail lever toward the front of the printer to open the
paper bail.
Fit the mounting brackets of the Pull Tractor Unit onto the shaft of the
printer mechan~m, tilting the Pull Tractor Unit slightly backward.
I
Figure 7-12. Fit the mounting bracketsof the Pull Tractor Unit onto the shaft of the printer.
5. Secure the Pull Tractor Unit firmly by pushing the lock levers on either
side, as shown in Figure 7-13.