Filter
Top Products
Chapter 2 System Setup 23
How to Install the System Into the Rack
This procedure assumes that the slide assembly is already installed in the rack, and
that the rack is stabilized and ready for you to insert the system safely. For
additional information on installing the slide assemblies and about rack enclosures,
see the Sun Fire 280R Server Setup and Rackmounting Guide and “About System
Rackmounting” on page 21.
Caution – The chassis is heavy. Two persons are required to place the system into
the rack slide assembly in the following procedure.
Before You Begin
Complete these tasks:
■ Assemble the correct tools for the procedure. See “Tools Required for Setup and
Rackmounting” on page 14.
■ Extend the cabinet’s anti-tip legs.
Caution – Unless the rack is bolted to the floor, you must extend the cabinet’s anti-
tip legs and adjust their stabilizing feet to the floor. Level and secure the cabinet to
provide a safe working environment.
■ Identify a person to assist you, and a cart to help move the system(s).
■ Discuss each task step and verify that your helper can safely lift and carry 34 lb
(17 kg), which is approximately half the weight of a fully-equipped system.
■ Open and remove the rack enclosure front door.
Caution – When completing a two-person procedure, always communicate your
intentions clearly before, during, and after each step to minimize confusion.