Filter
Top Products
58 Sun Fire 280R Server Owner’s Guide • January 2001
2. Plug in the TPE cable to the appropriate RJ-45 connector.
You should hear the connector tab snap into place.
3. Plug in the other end of the cable to the TPE outlet port in the wall or the floor.
Caution – Ensure that you plug this connector into the TPE RJ-45 port and not any
phone RJ-45 port. You can damage your TPE equipment if you use the incorrect port.
You should hear the connector tab snap into place.
See your network administrator if you need more information about how to connect
to your network, and to which port in the wall.
What Next
If you are installing your system, complete the installation procedure. Return to:
■ “How to Install the Sun Fire 280R Server” on page 15
If you are installing additional interfaces to the system, then you need to configure
those interfaces; see:
■ “How to Add an Ethernet Interface” on page 54
RSC TPE connector
System TPE connector