Filter
Top Products
2-10 Netra CP3260 Blade Server User’s Guide • April 2009
2.5.1.1 To Remove FB-DIMM Memory Modules
You might need to remove a FB-DIMM module from the Netra CP3260 blade server
if you are returning the FB-DIMM module or the blade server for service, or if you
are replacing a module with another FB-DIMM module.
Note – Safely store the original factory-shipped FB-DIMM and related FB-DIMM
packaging. You might wish to store any removed FB-DIMM in the new FB-DIMM
packaging, or use the packaging for service.
To remove a FB-DIMM from the Netra CP3260 blade server, perform the following
steps:
1. Take antistatic precautions: attach and electrically ground the wrist strap.
Caution – Always wear a grounded antistatic wrist strap when handling modules.
2. Place the Netra CP3260 blade server on an antistatic mat, or on the blade
server’s antistatic bag if you do not have a mat available.
3. For the FB-DIMM you wish to remove, simultaneously pull both FB-DIMM
retainer clips outward from the slot (see
➊ in FIGURE 2-2).
4. Grasp the FB-DIMM by the edges, and carefully pull it out of its connector (see
➋ in FIGURE 2-2). A slight rocking motion might be required.
Caution – Take extra care to prevent damage when removing the outer most
FB-DIMMs.
5. Place it in an antistatic bag.