Filter
Top Products
Chapter 2 Hardware Installation 2-15
Caution – Risk of explosion if the battery is replaced by an incorrect type.
Dispose of batteries properly in accordance with manufacturer’s instructions and
local regulations.
To install the battery, perform the following steps:
1. Remove the FB-DIMM closest to the front panel.
To do this, see Section 2.5.1.1, “To Remove FB-DIMM Memory Modules” on
page 2-10.
2. (Optional) Remove the old battery if necessary.
3. Slide the new battery into the holder with the side labeled “+ “ facing up.
4. Re-install the FB-DIMM.
To do this, see Section 2.5.1.2, “To Install FB-DIMM Memory Modules” on
page 2-11.