Filter
Top Products
4-8 Netra CP3260 Blade Server User’s Guide • April 2009
4.3.3.2 probe-ide Command
The probe-ide command communicates with all Integrated Drive Electronics (IDE)
devices connected to the IDE bus. This is the internal system bus for media devices
such as the DVD drive.
Caution – If you used the halt command or the Stop-A key sequence to reach the
ok prompt, issuing the probe-ide command can hang the system.
The following shows sample output from the probe-ide command.
4.3.3.3 show-devs Command
The show-devs command lists the hardware device paths for each device in the
firmware device tree. The following shows some sample output.
CODE EXAMPLE 4-2 probe-ide Command Output
{0} ok probe-ide
Device 0 ( Primary Master )
ATA Model: FUJITSU MHV2040BH
Device 1 ( Primary Slave )
ATA Model:
Device 2 ( Secondary Master )
Not Present
Device 3 ( Secondary Slave )
Not Present
CODE EXAMPLE 4-3 show-devs Command Output
{0} ok show-devs
/pci-performance-counters@0
/ebus@c0
/pci@0
/niu@80
/cpu@3f
/cpu@3e
/cpu@3d
/cpu@3c
/cpu@3b
/cpu@3a
/cpu@39
/cpu@38