Filter
Top Products
Chapter 2 Hardware Installation 2-11
FIGURE 2-2 Removing an FB-DIMM Memory Module
6. If you are replacing the module you removed with a new FB-DIMM, install it
as described in Section 2.5.1.2, “To Install FB-DIMM Memory Modules” on
page 2-11.
2.5.1.2 To Install FB-DIMM Memory Modules
The following procedure provides a general guide for installing additional memory.
However, for directions on the installation process of the memory FB-DIMMs on the
Netra CP3260 blade server, refer to the documentation that shipped with the
memory module.
Caution – Do not remove the FB-DIMM from its antistatic container until you are
ready to install it on the card. Handle the module only by its edges. Do not touch
module components or metal parts. Always wear a grounded antistatic wrist strap
when handling modules.