Filter
Top Products
2-18 Netra CP3260 Blade Server User’s Guide • April 2009
2.6 Installing an Advanced Rear Transition
Module (Optional)
For rear I/O access, a compatible RTM must be used with the Netra CP3260 blade
server.
Note – If you are using a Netra CP32x0 ARTM, refer to the appropriate Netra
CP32x0 ARTM User’s Guide for specific installation instructions.
In general, install the RTM from the rear of the server. Look at the front of the server
and locate the slot number where the Netra CP3260 blade server is installed. Then
go to the back of the server and install the RTM in that particular slot.
Figure Legend
1 TOD battery location
2 Remove this FB-DIMM for access to battery
3 TOD clock battery location with FB-DIMM removed