Filter
Top Products
At A Glance
1760 Series Component Waveform/Vector Monitor User Manual
2-5
H TIME CODE provides monitoring of longitudinal
time code in a frame-rate display.
H
MULTIPLE allows simultaneous selection of WAVE-
FORM
and VECTOR DISPLAY modes.
SWEEP
Sweep buttons are used to select the waveform sweep rate.
H
LINE/FIELD toggles through four sweep rate selec-
tions: one line, two line, one field, and two field.
Two line and two field selections not available with
PARADE or A123 or B123 display.
H
MAG turns on the sweep magnifier. See page 3-6.
DC REST
H RESTORE turns the DC Restorer on or off. Set DC
restorer speed and clamp point through the
CON-
FIGURE
menu, shown on page 3-20.
REF
H EXT toggles between external (EXT LED on) and
internal reference. Internal reference can be config-
ured for component operation, and two external
reference inputs can be designated for dual-standard
instruments. See
CONFIGURE menu on page 3-20.
INPUT
H Selecting a front-panel input causes the signal that is
input to the corresponding rear-panel connector to
be displayed on screen.