Filter
Top Products
Operator’s Checkout Procedure
1760 Series Component Waveform/Vector Monitor User Manual
2-23
10. Vectorscope Display
Select
VECTOR display mode. Adjust the right bezel control
to place the burst vector on the 180° graticule line. The
display should appear similar to Figure 2-14.
11. Picture Monitor Display
Select
PICTURE display mode. A picture monitor display of
the selected input signal appears. This can be used to visual-
ly identify the signal source. See Figure 2-15.
12. Audio Display
To obtain an audio display, connect the left and right audio
signals to the rear-panel REMOTE connector as follows: +Y
to pin 8, --Y to pin 9, +X to pin 10, a nd --X to pin 11. Select
AUDIO display mode.
An audio signal with no phase error appears as a straight line
extending from the audio box in the upper ri ght corner of the
graticule to the box in the lower left. A signal with phase
error appears as an opening in a lissajous waveform. See
Figure 2-16.
VECTOR PHASE
Figure 2-14. Vectorscope c olor bar display.