Filter
Top Products
AT Commands
Page 103
ATSn= Set S Register Value
The Sn= commands enables you to change the value in a Special Register (S Register).
The format for the command is:
ATSn=x
where n is the number of the S Register whose value you wish to change and x is the value you
wish to place in the register.
For example:
The character interrpreted as being a carriage return, is determined by the value in S Register 3.
The default value of this register is 13. To change this value to 15:
• Type: ATS3=15 <E>
It is important to alter values only in those S Registers listed for your modem. Placing a value in
any other S Register can have unforeseen consequences. Default values and the permissable
range of values for each S Register are detailed in the S Register section of this guide.
Options
ATS2=2 Set S Register 2 with a value of 2
See Also
Sn? command Display S Register Value