Filter
Top Products
Page 162
AT%R CTS Override
The %R command allows you to determine the state of the CTS signal.
This command is intended to replace the CTS switch if your modem does not have one (eg
Pocket & Rack Modems) This command overrides any &R setting.
☞☞
☞☞
☞
The %R command does not revert to the default setting after an ATZ, AT&F or
modem power off is performed.
Options
AT%R0 ■ &R command determines the state of CTS
AT%R1 CTS always follows RTS (both in on-line state and local command state)
AT%R2 V.25bis mode: CTS on when ready to accept a command
See Also
&R Sync RTS/CTS control
S Register 26 RTS/CTS Delay
Range
0-2