Filter
Top Products
Abbreviated Command List
Page 257
&F1 Select non-error correction factory
defaults
&F2 Select synchronous mode factory
defaults
&G0 ■ Do not generate guard tones
&G1 Generate guard tones of 550Hz
&G2 Generate guard tones of 1800Hz
&H0 ■ Clock always present in
synchronous mode
&H1 Clock only appears after
connection
&K0 Flow control disabled
&K3 ■ RTS/CTS (hardware) flow control
&K4 XON/XOFF (software) flow control
&K5 Transparent XON/XOFF flow
control
&K9 Failsafe flow control
&L0 ■ PSTN mode
&L1 Leased-line mode
&L2 Auto leased line Originate mode
&L3 Auto leased line Answer mode
&M0 ■ Asynchronous mode
&M1 Synchronous mode with
asynchronous dialling
&M2 Synchronous mode with dialling
invoked by the DTR signal
&M4 Asynchronous mode with dialling
invoked by the DTR signal
&N0 Disable abort connection
&N1 ■ Enable abort connection
&R0 ■ CTS follows RTS when the modem
is on line.
&R1 CTS is always asserted.
&S0 ■ DSR signal will always be asserted
&S1 DSR signal asserted at the start of
handshake
&S2 DSR signal asserted at end of
handshake (before CONNECT
message)
&Vn View Active Configuration Profile
&V0 View stored configuration profile 0
&V1 View stored configuration profile 1
&V2 View stored configuration profile 2
&V3 View stored configuration profile 3
&V8 View differences between active
configuration and default settings of
the S Registers
&Wn Write Configuration Parameters
&W0 Save current configuration into
profile 0
&W1 Save current configuration into
profile 1
&W2 Save current configuration into
profile 2
&W3 Save current configuration into
profile 3
&X0 ■ Synchronous clocks generated by
Modem.
&X1 Clocks generated by computer -
external clocking.
&X2 Clocks generated by remote system
- slave clocking.
&Y0 Select stored profile 0 on power up
&Y1 Select stored profile 1 on power up
&Y2 Select stored profile 2 on power up
&Y3 Select stored profile 3 on power up
&Z Stored Phone Number
#A0 Prevent remote access
#A1 Allow remote access
#A2 ■ Allow remote access with security
password
#B0 ■ B0 = V.23 B2 = V.22
#B1 B0 = V.22 B2 = V.23
#C0 V.25 calling tones disabled
#C1 ■ V.25 calling tones enabled
#CID0 ■ Caller ID
disabled
#CID1 Caller ID enabled
#CID2 Caller ID enabled with
response to host in hex format
#CID3 Caller ID enabled with
extended response
#D0 ■ Disable direct calling procedures
#D1 Enable direct calling procedures
#E0 ■ DES encryption disabled
#E1 DES encryption enabled
#E2 SuperSecure enabled (some models
only)
#E3 DES MultiKey
#E4 DES AutoIV
#H Display Help
#I0 ■ V.22bis leased line normal
#I1 Use non-standard PSTN V.22bis
over leased line
#J0 Assume V.42 capable