Filter
Top Products
Page iii
AT\V Error Correction Response Codes
The \V command allows you to select the error correction response codes when an error
corrected connection is established. With error correction response codes enabled, the messages
are returned when a connection is established using error correction.
If the ATX0 command has been issued, only the CONNECT/REL will be generated by the
modem, regardless of the connection speed, after the \V1 command is issued.
☞☞
☞☞
☞
Your communications software may not expect the modem to return error
correction response codes. If this is the case, disable the error correction response
codes. When disabled, the modem will generate standard CONNECT messages for
both error correction and normal connections.
Options
AT\V0 ■ Disable error correction response codes
AT\V1 Enable error correction response codes
AT\V8 Enable error correction response codes plus details of the error correction
and data compression negotiated with the remote modem is displayed
immediately before the CONNECT message.
AT\V9 Enable error correction response codes plus details of the error correction
and data compression negotiated with the remote modem and diagnostic
information displayed immediately before the CONNECT message.
See Also
X command Extended Response Codes
%U command V.42 Response Codes
Range
0-1, 8-9