Filter
Top Products
Page 44
Accessing a System Using SuperSecure
If both your modem and the remote modem have been correctly setup you can: q Dial the
remote system.
❑ The modems will connect and enter security dialog mode using the modem’s primary key.
❑ This key must be the same for both modems.
• Enter your username
• Press ENTER
• Enter your user password stored in the remote modem then ‘/’
• Enter your password stored in your modem
• Press ENTER
☞☞
☞☞
☞
You may backspace to correct errors but you will not be able to see what is typed
since all characters are echoed as #
• Do not use the / character in any password
• If the password is the same on both modems then only one password needs to be entered
Connection
❑ You will then CONNECT if the username, both passwords, all of the KEYS, IVs and KEs
match.
❑ The data will be correct and error free, but encrypted on the line using a KEY unknown to
anyone.
Disconnection
❑ If the primary DES KEY mis matches you will not be able to read the “username” prompt.
❑ The modems will disconnect if:
• The secondary key, IV or KE mismatches (you will also receive a message)
• An error corrected link cannot be established
• Wrong username and/or password is used. You will be given another two chances to enter
them before the modem disconnects
Example:
ATDT 456 4321
RINGING
RINGING
Enter name: MarkStein
Enter password: Fudge/Vanilla
Access granted