Filter
Top Products
AT Commands
Page 113
AT&F Restore Factory Defaults
Your modem comes with factory default settings for all communications settings and S Registers.
The &F command enables you to restore the factory default values to the command settings and
S Registers. This command does not reset stored phone numbers, security, or encryption
settings.
The &F1 command selects non-error correction factory defaults. The defaults selected are:
X0 &K0 &D2 \N1 %C0
The &F2 command selects synchronous mode factory defaults. The defaults selected are:
B13 E0 Q1 &M2
You must use the &W command if you wish to save the default values to nonvolatile memory,
and thus preserve these values when you switch the modem off.
☞☞
☞☞
☞
If you issue the &F command while the modem is off-hook, an ERROR message
will be returned.
Options
AT&F0 Restore Command and S Registers to Factory Defaults
AT&F1 Select non-error correction factory defaults
AT&F2 Select synchronous mode factory defaults
See Also
&V command View the Active Configuration
Z command Restore Configuration
&W command Save Configuration