Filter
Top Products
Page 184
AT*W Welcome Message Text
The *W command allows the user to specify the message that will be sent to the originating
modem immediately after CONNECT if the %W1 Welcome Message is enabled.
The message may contain any text limited only by the maximum command line size (80). The
message may include new lines which are indicated by using the ‘|’ character.
If %W1 is enabled the text you have specified will be displayed at the end of the &V display.
Examples
AT*W You are connected to a Telenetics Global Carrier
This will send the following text to the remote modem after connection:
You are connected to a Telenetics Global Carrier
See Also
%W Enable Welcome Message