Filter
Top Products
128
5.USING THE EDITING FUNCTIONS
13.JOB BUILD (Cont.)
5
7
After scanning is completed, the [JOB
FINISH] button is displayed on the screen.
Each button has the following functions.
- [JOB FINISH] button: All of the scanned originals are outputted as
the settings, they are stored if this was set, and then the settings
of JOB BUILD are released.
8
Place the originals of the 2nd job.
9
On the Basic screen, set the settings for
the 2nd job.
- The settings for the 2nd job or later can be changed with regard
to the following functions.
Reproduction ratio, automatic magnification selection, original
size, other size
Scanning mode
Image adjustment mode
Edge erase, dual-page
- When the 1st job is set and 2-sided copying (or 1-sided copying)
is selected, the setting cannot be changed to 1-sided copying (or
2-sided copying) from the 2nd job.
- Press the [SETTING] button to confirm the settings.
- To change the settings, press the [FC] button, and then start the
procedure again from step 1.
- Be aware that copying will be performed in the same modes as
those of the 1st job if the copy modes are not changed.
10
After having completed the settings,
press the [START] button.
- Scanning the originals starts.
- For the 3rd job or later, repeat from step 7 to 10.
- Any number of jobs can be set until the total number of scanned
original pages reaches 1000.