Filter
Top Products
5
5-4
TROUBLESHOOTING
1. TROUBLESHOOTING (Cont.)
Error Message
Solution
Press
to restore the idle state. If this
Error Message is repeatedly displayed,
machine programming has become corrupted.
The machine must be reinitialized by a trained
technician. Call for service.
Press
to restore the idle state.
Retry the transmission.
Press
to restore the idle state.
Retry the transmission.
Press
to restore the idle state.
Confirm the security code or telephone
number, and then retry the transmission.
Press to restore the idle state. Check
the POWER FAILURE LIST that was output for
information on any lost communication.
Press
to restore the idle state.
<Memory full during transmission>
Wait for the memory to become available and
then retry memory transmission, or perform a
direct transmission.
<Memory full during reception>
Contact the other party to re-transmit the
document.
Error Message
Broken registration
Line busy
Communication
error
Feature unavailable
Power failure
Memory is full
Cause
Auto dialer numbers and initial set-
ting have been lost (due to a lengthy
power failure, depleted battery, etc.)
A direct transmission was made to
a remote fax that was busy.
A communication error occurred
during a transmission.
• Communication error resulting
from a security code disagreement
during a MAILBOX transmission.
• Communication error resulting
from a telephone number conflict
during a security transmission.
Reserved jobs or received image
data were erased due to a lengthly
power failure.
The memory became full during
data entry into memory during a
transmission or reception.
When an abnormality occurs inside the copier or the copier is operated improperly, an error message is
displayed on the LCD. Take the appropriate action by referring to the following chart.
For error messages that are not described below, refer to the Copying Function in the Operator’s Manual.
Note
When the message “Misfeed in xxxx”, “CASSETTE xx empty”, “LCF empty”, “Add paper”, “Toner
empty”, or “Replace process unit” is displayed, memory reception may be performed. Clear the message
without turning off the power.