Filter
Top Products
General Precautions for Installation/Servicing/Maintenance
for the MR-3018
The installation and service should be done by a qualified service technician.
1) When installing the MR-3018 to the Equipment, be sure to follow the instructions described in the
“Unpacking/Set-Up Procedure for the MR-3018” booklet which comes with each unit of the MR-
3018.
2) The MR-3018 should be installed by an authorized/qualified person.
3) Before starting installation, servicing or maintenance work, be sure to turn OFF and unplug the
equipment first.
4) When servicing or maintaining the MR-3018, be careful about the rotating or operation sections
such as gears, pulleys, sprockets, cams, belts, etc.
5) When parts are disassembled, reassembly is basically the reverse of disassembly unless otherwise
noted in this manual or other related materials. Be careful not to reassemble small parts such as
screws, washers, pins, E-rings, toothed washers to the wrong places.
6) Basically, the machine should not be operated with any parts removed or disassembled.
7) Delicate parts for preventing safety hazard problems (such as switches, sensors, etc. if any) should
be handled/installed/adjusted correctly.
8) Use suitable measuring instruments and tools.
9) During servicing or maintenance work, be sure to check the serial No. plate and other cautionary
labels (if any) to see if they are clean and firmly fixed. If not, take appropriate actions.
10)The PC board must be stored in an anti-electrostatic bag and handled carefully using a wristband,
because the ICs on it may be damaged due to static electricity. Before using the wrist band, pull out
the power cord plug of the equipment and make sure that there is no uninsulated charged objects in
the vicinity.
11)For the recovery and disposal of used MR-3018, consumable parts and packing materials, follow the
relevant local regulations/rules should be followed.
12)After completing installation, servicing and maintenance of the MR-3018, return the MR-3018 to its
original state, and check operation.