Filter
Top Products
MR-3018 DISASSEMBLY AND ASSEMBLY June 2005 © TOSHIBA TEC
4 - 14
[J] Pre-reading roller
[K] Platen roller / post-reading roller
(1) Take off the pre-reading upper guide.
( P.4-13 "[H] Pre-reading lower guide /
pre-reading upper guide")
(2) Take off the read motor drive section.
( P.4-19 "[C] Read motor drive section")
(3) Remove 1 bushing and 1 E-ring from the rear
side of the pre-reading roller shaft. Loosen 2
setscrews and take off 1 flange. Then take
off 1 pulley and 1 bearing.
Fig.4-38
(4) Remove 1 clip and 1 bushing from the front
side of the pre-reading roller shaft.
(5) Take off the pre-reading roller.
Fig.4-39
(1) Take off the pre-reading lower guide.
( P.4-13 "[H] Pre-reading lower guide /
pre-reading upper guide")
(2) Disconnect 1 connector.
Fig.4-40
Flange
E-ring
Pulley
Bearing
Bushing
Pre-reading roller
Bushing
Clip
Connector