Filter
Top Products
June 2005 © TOSHIBA TEC MR-3018 DISASSEMBLY AND ASSEMBLY
4 - 13
4
[H] Pre-reading lower guide / pre-reading upper guide
[I] Intermediate transport roller
(1) Take off the front cover.
( P.4-1 "[A] Front cover")
(2) Take off the rear cover.
( P.4-2 "[B] Rear cover")
(3) Take off the jam access cover.
( P.4-2 "[C] Jam access cover")
(4) Take off the left cover.
( P.4-3 "[D] Left cover")
(5) Remove 4 screws and take off the pre-read-
ing lower guide.
Fig.4-35
(6) Disconnect 2 connectors. Remove 2 screws
and take off the pre-reading upper guide.
Fig.4-36
(1) Take off the pre-reading upper guide.
( P.4-13 "[H] Pre-reading lower guide /
pre-reading upper guide")
(2) Take off the read motor drive section.
( P.4-19 "[C] Read motor drive section")
(3) Remove 1 bushing, 1 E-ring, 1 pulley, 1 pin
and 1 bushing from the rear side of the inter-
mediate transport roller shaft.
(4) Remove 1 bushing from the front side of the
intermediate transport roller shaft.
(5) Take off the intermediate transport roller.
Fig.4-37
Pre-reading lower guide
Pre-reading upper guide
Bushing
E-ring
Pulley
Pin
Bushing
Intermediate transport roller
Bushing