Filter
Top Products
June 2005 © TOSHIBA TEC MR-3018 Adjustment
5 - 1
5
5. Adjustment
5.1 Adjustment of Position
Perform this adjustment when the RADF is not installed in the correct position.
Note: Note:
Check if the image adjustment for the equipment is performed properly before this adjustment of
the RADF. (See the Service Handbook of the applicable equipment.)
[A] Checking
(1) Open the RADF and install 2 positioning pins
(the positioning pins are installed to the back
side of the hinge which is on the left side of
the RADF).
Fig.5-1
(2) Remove the platen sheet.
Fig.5-2