Filter
Top Products
June 2005 © TOSHIBA TEC MR-3018 Adjustment
5 - 13
5
5.5 Adjustment of Horizontal Position
Note: Note:
Check if the image adjustment for the equipment is performed properly before this adjustment of
the RADF. (See the Service Handbook of applicable equipment.) Also, the RADF position and
height shall be adjusted properly.
[A] Checking
Check the image using the chart (original) with a center line in the following procedure.
(1) Place the chart provided as an original with its face up on the original tray of the RADF.
(2) Press the [START] button.
(3) Fold the copy in half and check if the center line is misaligned.
[B] Adjustment
(1) Turn the power ON while pressing [0] and [5] simultaneously.
(2) Key in [358] and then press the [START] button.
• If the center line of the copy image is shifted to the front side of the equipment, enter a value
larger than the current one.
Note: Note:
Changing one value shifts the copy image by 0.042 mm.
Fig.5-26
• If the center line of the copy image is shifted to the rear side of the equipment, enter a value
smaller than the current one.
Note: Note:
Changing one value shifts the copy image by 0.042 mm.
Fig.5-27
(3) Press the [ENTER] button.
G
H