Filter
Top Products
June 2005 © TOSHIBA TEC MR-3018 DISASSEMBLY AND ASSEMBLY
4 - 11
4
[F] Registration roller
[G] Exit/reverse roller
(1) Take off the feeder lower guide.
( P.4-10 "[E] Feeder lower guide")
(2) Take off the original feed motor drive section.
( P.4-21 "[E] Original feed motor drive sec-
tion")
(3) Remove 1 E-ring and 1 bushing from the
front side of the registration roller shaft. Also,
remove 1 bushing, 1 pulley, 1 E-ring and 1
bushing from the rear side of the shaft, and
then take off the registration roller.
Fig.4-29
(1) Take off the front cover.
( P.4-1 "[A] Front cover")
(2) Take off the original exit/reverse motor.
( P.4-23 "[F] Original exit/reverse motor
(M3)")
(3) Remove 1 clip, 1 pulley, 1 pin and 1 bushing
from the rear side of the exit/reverse roller
shaft.
Fig.4-30
(4) Remove 1 screw and take off the leaf spring.
(5) Remove 1 clip and 1 bushing from the front
side of the exit/reverse roller shaft.
Fig.4-31
E-ring
Bushing
Pulley
E-ring
Bushing
Bushing
Registration roller
Bushing
Pin
Pulley
Clip
Bushing
Clip
Leaf spring