Filter
Top Products
MR-3018 Adjustment June 2005 © TOSHIBA TEC
5 - 8
5.3 Adjustment of Skew
Note: Note:
Check if the image adjustment for the equipment is performed properly before this adjustment of
the RADF. (See the Service Handbook of applicable equipment.) Also, the RADF position and
height shall be adjusted properly.
[A] Checking
Check the image using the chart (original) with vertical and horizontal lines in the following procedure.
Fig.5-17 Chart (Original)
Simplex copying:
(1) Place the chart provided as an original with its face up on the original tray of the RADF, select [1
Sided -> 1 Sided] and press the [START] button.
(2) Superimpose the chart on the copy and check the inclination of the copy image.
Duplex copying:
(1) Place the chart provided as an original with its face up on the original tray of the RADF, select [2
Sided -> 2 Sided] and press the [START] button.
(2) Superimpose the chart on the copy and check the inclination of the copy image.