Filter
Top Products
Satellite R10 7-5
HW Setup
HDD Priority Options
If more than one HDD is installed in the computer, this option lets you set
the priority for HDD detection. If the first detected HDD has a boot
command, the system will boot from the HDD.
Network Boot Protocol
This feature sets the protocol to remotely boot from the network.
[PXE]Sets PXE as the protocol (Default).
[RPL]Sets RPL as the protocol.
Keyboard
Wake-up on Keyboard
When this feature is enabled and the computer is in Standby mode, you can
turn on the computer by pressing any key. It is effective only for the internal
keyboard and only when the computer is in standby mode.
CPU
This function lets you set the CPU operating mode.
Dynamic CPU Frequency Mode
This option lets you choose from the following settings:
Built-in HDD −>
2nd HDD (Default)
The computer will look for the Built-in HDD first,
next the 2nd HDD and then the HDD (Default).
2nd HDD −>
Built-in HDD
The computer will look for the 2nd HDD first and
then the Built-in HDD.
■ If a boot command is not found on the first detected HDD, the system
will not boot from the other HDD. It will search the next device in the
boot priority for a boot command.
■ Some modules may not be displayed.
Enabled Enables the Wake-up on Keyboard.
Disabled Disables the Wake-up on Keyboard (Default).
It is displayed in Pentium-M
®
model only.
Dynamically
Switchable
CPU power consumption and clock speed
automatic switching function is enabled. When
the computer is in use, CPU operation is
automatically switched when necessary (Default).