Filter
Top Products
STEP 3: CALIBRATE THE SCANNER 17
8. Remove the page and replace it in its plastic bag.
Do not discard the calibration page. You may need it periodically to
calibrate the scanner to keep it operating at peak performance.
9. Click Next on the Calibration window.
10. Click Finish on the Completing the Found New Hardware Wizard
window.
Do not proceed until you receive a message that your computer has
found the new hardware, or updated the driver database. If your
computer is running Windows XP or Vista you will see a message
similar to this one.
Note: If the page does not back out of the scanner, the calibration
may not have finished properly. Remove the page and complete the
installation of your scanner, then see the section, “Recalibrating and
Cleaning Your Scanner” on page 141 to run the calibration again.