Filter
Top Products
Vixel Model 335 Installation & Configuration Guide CHAPTER 2 Installation
7
Port LEDs
Port LEDs indicate the current status of the particular port.The switch uses two port
LEDs: SFP Status and Port Bypassed/Port Activity. The Port Bypassed and Port Activity
LEDs share the same yellow/green LED.
Figure 2-3. Port LEDs
System LEDs Indication
Power
(green LED)
When lit, the switch is plugged in and the internal power
supply is functional.
Switch Fault
(yellow LED)
Indicates that the internal hardware self-test failed. When
lit, the switch will not function. -or-
Indicates that a fan has stopped operating or the ambient
temperature has exceeded 45°C. When lit, the switch is still
functional but requires immediate attention. The LED will
turn off when the detected condition is corrected.
Switch Op
(green LED)
Indicates whether the zones are initialized and operational.
If the Switch Op LED is lit, all zones with inserted devices
are operational. If the Switch Op LED is blinking in a
multiple zone configuration, one or more zones are
operational while others are not. If the Switch Op LED is
off, no operational zones exist or no devices are attached.
2 Gb/s
(green LED)
Indicates the current operational speed of the switch. When
lit, the switch is operating at 2 Gb/s. If unlit, the switch is
operating at 1 Gb/s.
Mgmt Present
(yellow LED)
Indicates that switch management is functioning. If
flashing, indicates that management functionality has failed
and is not communicating with the switch.
Enet Active
(green LED)
Indicates Ethernet activity on the switch and is controlled
through the Ethernet transceiver.