Filter
Top Products
Vixel Model 335 Installation & Configuration Guide CHAPTER 3 Management
25
3. Click Submit to accept the changes.
4. Click Back to Port Usage to view the new settings.
Port Settings
The Port Information page displays the port status for each port on the switch.
To view the port settings, click Port. The Port Information page appears.
Figure 3-15. Port Information Page
The displayed settings are listed below:
Setting Description
Port The actual port on the switch.
Transceiver The type of transceiver inserted in the port.
Trcvr LED If a transceiver is inserted properly, the LED is on.
Fault LED The port is bypassed due to a problem detected by either the
transceiver’s transmit logic or the SFP transceiver itself.
Transceiver problems include unconnected fiber, remote node
not transmitting, LIP(F8), or a faulty transceiver.
State The current state of the selected port.
TX The state of the transmitter on the selected port.
Inserts The number of times a transceiver has been inserted into the
port since the last switch reset.
Freq The port locked in on the communicating frequency for which
the switch is configured.
Zone The zone in which the port is located.
Cascade Mode Displays the cascade mode for the specified port.
Cascade State Displays the cascade state for the specified port.