Filter
Top Products
Vixel Model 335 Installation & Configuration Guide APPENDIX B CLI Console Commands
61
Show Hardware
Menu
sh Displays hardware information and versions.
Show Enclosure
Menu
se Displays information on fan status, temperature,
controller status, and management status.
Show Diagnostics
Menu
sd Displays diagnostic registers for the default port.
This includes the detector, match, control, capture
and tx registers.
Show Zone zo
zo <ZoneID>
Displays information for the default switch’ s zone,
including general and port-specific information.
Provides a menu selection for each zone.
Show Port po
po <port ID>
Displays all information concerning a specific port.
When a port number is entered, the default port
number (1) will be changed to the new port
number. This command also allows changing port
policies.
Show Port Serial
Transceiver Data
sid Displays the serial ID information of the
transceiver in the default port.
Show Port Clock
Delta Register
pcdr
pcdr <port ID>
Reads the port Clock Delta register. Enter a specific
port number for the portID.
Show Zone Table sz Displays general status of all zones on the switch.
Provides a menu selection for each zone.
Show Port Table sp Displays general status of all ports for the default
zone. Provides a menu selection for each port.
Show Revision
Table
rev Displays the revision levels of the installed
firmware.
Show Sensor Table sen Displays Fan/PS/Temperature sensor status.
Show Switch Sweep ss
sweep
Displays the results of a single switch diagnostic
sweep.
Show MIB Event
Log
ev
ev <eventID>
ev cl<ear>
ev re<set>
Displays all event log entries, or all event log
entries after <eventID>. The Clear option clears
events up to the current time – after which a return
will display new events only. The reset starts at the
beginning of the event buffer. Up to 512 events are
stored in the buffer.
Show Fibre Alliance
Event Log
faev Displays event log entries based upon the selected
severity level.
Show Operating
System Stacks
stack Displays commands in the operating system stacks.
Action Commands
Reset Switch rs Resets the switch and ASIC.
Reset Switch
Hardware
rh Resets the ASIC.
Reset Switch
Configuration
rc Resets the switch to factory default settings.
Link Speed lsp Sets the switch speed at 1 Gb/s or 2 Gb/s.
Command Syntax Action