Filter
Top Products
Vixel Model 335 Installation & Configuration Guide CHAPTER 3 Management
14
System Information Settings
The System Informations page displays the switch’s parameters and general
configuration settings.
To view the system settings, click System. The System Information page appears.
Figure 3-2. System Information Page
The displayed settings are listed below:
Setting Description
MAC Address A unique device address assigned to each switch at the
factory. Cannot be configured or modified.
Serial Num(ber) A unique identification number assigned to each switch at the
factory. Cannot be configured or modified.
IP Address The current IP Address for the switch.
IP Gateway The current Gateway address for the switch.
IP Netmask The current IP Netmask address for the switch.
Speed The current speed setting for the switch.
Speed Control (Last boot) The speed setting selected during the last switch power-up.
Speed Control (Next boot) The speed setting selected for the next switch power-up.
Switching Mode When "on", allows data to be sent directly to a specified port.
If "off", the data is sent to every port. Disabling Switching
Mode may be necessary when passing data to legacy devices.
Blocking ARB When two ports start a communication session, the Blocking
ARB is sent to all other ports trying to communicate with
those ports until the connection is terminated. Blocking ARB
is only active when the switching mode is on.