Filter
Top Products
Vixel Model 335 Installation & Configuration Guide CHAPTER 3 Management
48
Ports
Displays all information concerning a specific port. When a port number
(e.g., 2) is entered, the default port number (1) is changed to the new port
number. You can also change the port policies.
To view port information, type
7 at the prompt. To see additional
information for a port, enter the desired port number.
Zone
Displays information for the default switch's zone (e.g., 1, 2, etc.),
including general and port-specific information. A menu selection is
available for each zone.
To view zone information, type
8 at the prompt.
When the user chooses to view a zone, all information for that zone is
displayed along with a port menu listing the ports in that zone.
Sweep
Displays ordered sets and error detectors for each port on the switch.
To perform a switch sweep, type
9 at the prompt.
Diagnostics
Displays diagnostic registers for the default port including the detector,
match, control, capture, and tx registers.
Note: These settings should not be modified unless directed to do so by
Vixel Customer Service.
To run diagnostics, type
10 at the prompt.
Reset counters
Resets all or specific counters to zero.
Options:
6–reset all port counters in switch
7–reset all RX frame counters in switch
8–reset all conn attempt counters in switch
9–reset all conn stall counters in switch
10–reset all CRC error counters in switch
11–reset all bad OS error counters in switch
To reset counters, type
11 at the prompt. Type the number for the desired
option.
Command Description