Filter
Top Products
60
APPENDIX B CLI Console
Commands
Console Commands
All of the commands below are ordered generally by category. The format of the
commands is given in the list, however, the “help” command at the command line may
give even more detail.
General Commands 60
Browse Commands 60
Action Commands 61
Command Syntax Action
General Commands
Configure co Displays information on the switch’s IP
parameters: IP Address, default gateway, and
netmask. You can also enable/disable DHCP.
System Information si Displays switch information such as switch name,
location, and contact.
Manage Firmware fw Displays the current firmware image and the
alternate image. You can also select to use the
alternate image or download new firmware.
Configure TRAP
Destination Table
ct Displays the current trap destination table and
allows you to create/delete trap destinations.
Log In li Prompts for password.
Log Out lo Exits the CLI session.
Set Password pw Sets new console password
Ping ping
ping <x.x.x.x>
Sends packets to specified device to confirm
communication between devices.
Help ?
? <cmd>
h
h <cmd>
help
help <cmd>
Displays all or specific help.
Browse Commands
Show Management
Menu
mc Displays overall status of the switch and its
policies. Allows configuration of policies and
thresholds.
Show Switch Menu sw Displays the current switching mode, blocking
AL_PA, and menu of switch informational
commands.