Filter
Top Products
Chapter 30 WAN and Dial Backup Setup
ZyWALL 2WG User’s Guide
556
30.4.2 Remote Node Profile (3G WAN)
Enter 2 in Menu 11 - Remote Node Setup to open Menu 11.2 - Remote Node Profile (3G
WAN) (shown below) and configure the setup for your 3G connection.
Figure 346 Menu 11.2: Remote Node Profile (3G WAN)
The following table describes the fields in this menu.
Menu 11.2 - Remote Node Profile (3G WAN)
Rem Node Name= WAN 2
Active= Yes
Edit IP= No
Outgoing: Edit Script Options= No
My Login= test
My Password= ********
Retype to Confirm= ********
Authen= CHAP/PAP
Pri Phone #= *99#
Always On= No
Session Options:
Edit Filter Sets= No
Idle Timeout(sec)= 100
Press ENTER to Confirm or ESC to Cancel:
Table 209 Menu 11.2: Remote Node Profile (3G WAN)
FIELD DESCRIPTION
Rem Node
Name
Enter a descriptive name for the remote node. This field can be up to eight
characters. WAN 2 denotes a 3G WAN connection but you can change that.
Active Press [SPACE BAR] and then [ENTER] to select Yes to enable the remote node or
No to disable the remote node.
Outgoing
My Login Enter the login name assigned by your ISP for this remote node.
My Password Enter the password assigned by your ISP for this remote node.
Retype to
Confirm
Enter your password again to make sure that you have entered is correctly.
Authen This field sets the authentication protocol used for outgoing calls.
Options for this field are:
CHAP/PAP - Your ZyWALL will accept either CHAP or PAP when requested by this
remote node.
CHAP - accept CHAP only.
PAP - accept PAP only.
Pri Phone # Enter the phone number (dial string) used to dial up a connection to your service
provider’s base station. Your ISP should provide the phone number.
For example, *99# is the dial string to establish a GPRS or 3G connection in Taiwan.