Filter
Top Products
Chapter 21 System Commands
ZyWALL (ZyNOS) CLI Reference Guide
155
sys logs consolidate period <1-
600>
Sets the log consolidation period (seconds). R+B
sys logs consolidate switch
<0:on|1:off>
Enables or disables log consolidation. R+B
sys logs display
[access|attack|error|ipsec|ike|j
avablocked|mten|packetfilter|pki
|tcpreset|urlblocked|urlforward]
Displays all logs or specific categories of logs. R+B
sys logs errlog clear Clears error logs. R+B
sys logs errlog disp Displays error logs. R+B
sys logs errlog online Turns the error log online display on or off. R+B
sys logs lastAlert <index> Displays the last #index alert in the centralized log. R+B
sys logs load Loads the log settings for editing. Use this command before
you configure the log settings. Use sys logs save after you
configure the log settings.
R+B
sys logs mail alertAddr [mail-
address]
Sets the e-mail address to which the ZyWALL sends alerts. R+B
sys logs mail auth
<0:enable|1:disable>
Enables or disables SMTP (Simple Mail Transfer Protocol)
SMTP authentication.
R+B
sys logs mail clearLog
[0:no|1:yes]
Sets whether or not the ZyWALL clears the log after sending
logs by e-mail.
R+B
sys logs mail display Displays the settings for e-mailing logs. R+B
sys logs mail logAddr [mail-
address]
Sets or displays the e-mail address to send logs to. R+B
sys logs mail passwd [smtp-user-
password]
Sets the SMTP authentication password. R+B
sys logs mail port [port] Sets the port number for sending log e-mails. R+B
sys logs mail schedule display Displays the log e-mail schedule. R+B
sys logs mail schedule hour <0-
23>
Sets the hour to send the logs. R+B
sys logs mail schedule minute <0-
59>
Sets the minute to send the logs. R+B
sys logs mail schedule policy
<0:full|1:hourly|2:daily|3:weekl
y|4:none>
Sets how often the ZyWALL sends log e-mails. R+B
sys logs mail schedule week
<0:sun|1:mon|2:tue|3:wed|4:thu|5
:fri|6:sat>
Sets the day of the week to send the e-mail log. R+B
sys logs mail senderAddr <mail-
address>
Specifies the e-mail address in the from/sender line of the log
e-mail message that the ZyWALL sends. If you activate SMTP
authentication, the e-mail address must be able to be
authenticated by the mail server.
R+B
sys logs mail server <domain-
name|ip>
Specifies the server name or the IP address of the mail server
for the e-mail address specified as the mail sender.
R+B
sys logs mail subject <mail-
subject>
Specifies the title in the subject line of the diagnostic e-mail
message that the ZyWALL sends.
R+B
Table 74 Logs Commands (continued)
COMMAND DESCRIPTION M