Filter
Top Products
ZyWALL (ZyNOS) CLI Reference Guide
169
CHAPTER 23
WWAN Commands
Use these commands to configure wireless WAN settings on the ZyWALL.
23.1 Command Summary
The following table describes the values required for many wwan commands. Other values are
discussed with the relevant commands.
The following section lists the commands for this feature.
Table 85 wwan Command Input Values
LABEL DESCRIPTION
networkmodeindex Specifies the index number of a listed network mode. You can find a list
of network types by entering the command “wwan card networkMode
show”.
string Enter a name with <31 ASCII characters unless otherwise specified.
Table 86 wwan Command Summary
COMMAND DESCRIPTION M
wwan card networkMode change
[networkmodeindex]
Changes the network type. R
wwan card networkMode show Shows a numbered list of available network types. The network
type available depends on the type of 3G card installed, for
example, UMTS, HSDPA, GPRS, EDGE, GSM.
R
wwan card serviceProv change
[networkmodeindex]
Changes the service provider. R
wwan card serviceProv show Scans for and shows a numbered list of the available cellular
service providers.
R
wwan card slot Shows information on the slot interface, for example, PCMCIA. R
wwan config apn <string> Sets the Access Point Name (APN) for an access point on a
GSM network.
R
wwan config authType [1|2|3|4] Sets the PPP authentication type.
1. None
2. CHAP only
3. PAP only
4. CHAP or PAP
If 1.None is selected, no password or user name is required.
R