Filter
Top Products
Chapter 10 Configuration Commands
ZyWALL (ZyNOS) CLI Reference Guide
69
config delete firewall attack send-
alert
Deletes the setting for whether an alert should be sent on
registering an attack.
R+B
config delete firewall attack tcp-
max-incomplete
Deletes the setting for DOS detection based on the
maximum number of sessions allowed with the same
destination host address.
R+B
config delete firewall e-mail Removes all settings for e-mailing the firewall log. R+B
config delete firewall e-mail day Deletes the setting for which day the firewall log e-mail is
sent.
R+B
config delete firewall e-mail
email-to
Deletes the setting for where the e-mail is sent to. R+B
config delete firewall e-mail hour Deletes the setting for which hour the e-mail is sent. R+B
config delete firewall e-mail mail-
server
Deletes the setting for which e-mail server is used to send
the e-mail.
R+B
config delete firewall e-mail
minute
Deletes the setting for which minute the e-mail is sent at. R+B
config delete firewall e-mail
policy
Deletes the setting for the schedule for when the e-mail is
sent.
R+B
config delete firewall e-mail
return-addr
Deletes the setting for the return address for the e-mail log. R+B
config delete firewall e-mail
subject
Deletes the setting for the subject of the e-mail log. R+B
config delete firewall set <set#> Removes the specified set of rules applying to traffic from a
given interface to another.
R+B
config delete firewall set <set#>
connection-timeout
Deletes the setting for the connection time out for traffic to
which this set applies. This command has no effect on
firewall settings. To configure timeout values use tos
commands
R+B
config delete firewall set <set#>
default-action
Deletes the setting for the default action for traffic to which
this set applies.
R+B
config delete firewall set <set#>
fin-wait-timeout
Deletes the setting for the wait time for FIN when
concluding a TCP session before it is terminated.
This command has no effect on firewall settings. To
configure timeout values use tos commands
R+B
config delete firewall set <set#>
icmp-timeout
Deletes the setting for the timeout for an idle ICMP session
before it is terminated.
This command has no effect on firewall settings. To
configure timeout values use tos commands
R+B
config delete firewall set <set#>
log
Deletes the log of traffic to which this set applies. R+B
config delete firewall set <set#>
name
Deletes the name of a set. R+B
config delete firewall set <set#>
rule <rule#>
Removes a specified rule in a set from the firewall
configuration.
R+B
config delete firewall set <set#>
rule <rule#> action
Deletes whether a packet is permitted, dropped or rejected
when it matches this rule.
R+B
config delete firewall set <set#>
rule <rule#> active
Deletes whether a rule is enabled or not. R+B
Table 27 config Command Summary (continued)
COMMAND DESCRIPTION M