Filter
Top Products
ZyWALL (ZyNOS) CLI Reference Guide
97
CHAPTER 15
IP Commands
Use these commands to configure IP settings on the ZyWALL.
15.1 Command Summary
The following table describes input values for some of the ip commands. Other values are
discussed with the corresponding commands.
15.1.1 ALG Commands
The following section lists the ALG commands.
Table 41 IP Command Input Values
LABEL DESCRIPTION
isp-group-idx The number of an ISP configuration on the ZyWALL. For example, the ISP
configured for the WAN 1 interface is ISP group index 1.0
number The number of system report records to display. For example, if you specify 10,
the top 10 report entries display.
Table 42 ALG Commands
COMMAND DESCRIPTION M
ip alg disable
<ALG_FTP|ALG_H323|ALG_SIP>
Turns off the specified ALG (Application Layer Gateway). R+B
ip alg disp Shows whether the ALG is enabled or disabled. R+B
ip alg enable
<ALG_FTP|ALG_H323|ALG_SIP>
Turns on the specified ALG. R+B
ip alg ftpPortNum [port] Sets the FTP ALG to support a different port number (instead
of the default).
R+B
ip alg siptimeout <timeout> Sets the SIP timeout in seconds. 0 means no timeout. R+B