Filter
Top Products
ZyWALL (ZyNOS) CLI Reference Guide
85
CHAPTER 12
Ethernet Commands
Use these commands to configure the settings of ethernet ports on ZyWALL.
12.1 Command Summary
The following section lists the commands for this feature.
Table 36 Ethernet Commands
COMMAND DESCRIPTION M
ether edit load <ether-number> Loads the ethernet configuration for the specified
interface.
ether-number:
Use the following for a ZyWALL with a single WAN
Ethernet interface.
1: lan
2: wan
3: dmz
4: wlan
Use the following for a ZyWALL with two WAN
Ethernet interfaces.
1: lan
2: wan
3: dmz
4: wan2
5: wlan
R+B
ether edit mtu <value> Sets the ethernet mtu size. R+B
ether edit speed <speed> Sets the ethernet speed in Mbps and duplex.
speed: auto,10/full,10/half,100/full,100/half
R+B
ether edit save Saves the ethernet configuration. R+B
ether dynamicPort set <port> <type> Sets the specified physical port mapping to DMZ,
WLAN, or LAN.
port: 1-4
type: DMZ, WLAN, LAN
R+B