Filter
Top Products
Chapter 2 Common Commands
ZyWALL (ZyNOS) CLI Reference Guide
27
Use these commands to enable anti-spam on the ZyWALL for traffic going from WAN1 to
LAN.
Use the following commands to enable anti-virus on the ZyWALL You first need to use the
load command.
Use the following commands to enable content filtering on the ZyWALL, then on the external
database (DB) and then display the default policy.
The default policy does not actually block anything. Use the following commands to edit the
default policy, turn the external database service content filtering (category-based content
filtering), see what the categories are, block a category 92 in the following example) and then
save the policy.
ras> as enable 1
Anti spam: enabled
ras> as dir wan1 lan on
From\To lan wan1 dmz wan2 wlan vpn
=======================================
lan off off off off off off
wan1 on off off off off off
dmz off off off off off off
wan2 off off off off off off
wlan off off off off off off
vpn off off off off off off
ras>
ras> av load
ras> av config enable on
ras> av save
ras> av disp
AV Enable : On
AV Forward Over ZIP Session : Off
AV Forward Over ZIP Session : Off
------------------------------------
ras> ip cf common enable on
ras> ip cf externalDB enable on
ras> ip cf policy displayAll
index Name Active IP Group
Start Addr End Addr
==========================================================================
1 Default Policy Y 0.0.0.0/0.0.0.0