Filter
Top Products
ZyWALL (ZyNOS) CLI Reference Guide
63
CHAPTER 9
CNM Agent Commands
Use these commands to configure CNM agent settings on the ZyWALL.
9.1 Command Summary
The following section lists the commands for this feature.
Table 25 CNM Commands
COMMAND DESCRIPTION M
cnm active [0:disable|1:enable] Enables or disables the CNM service on the ZyWALL.
After enabled, the ZyWALL communicates with the CNM
server through ZyWALL’s WAN.
R+B
cnm sgid Displays the unique ID received from the CNM server
after the ZyWALL registered successfully.
R+B
cnm managerIp Displays the CNM server's IP address. R+B
cnm debug [0:disable|1:enable] Controls whether the debugging information is displayed
on the console. You must change the baud rate to
115200 bps before enabling the CNM debug mode.
R+B
cnm reset Resets the CNM service to the initial status on the
ZyWALL. The ZyWALL will register itself to the CNM
server again if the service is enabled.
R+B
cnm encry [none|des|3des] [key] Displays or sets the encryption mode and key.
The encryption key is 8 characters when the encryption
mode is set to “DES”.
The encryption key is 24 characters when the encryption
mode is set to “3DES”.
R+B
cnm keepalive <10~90> Sets how often (in seconds) the ZyWALL sends a
keepalive packet to inform the CNM server of its
existence.
R+B
cnm version Displays the CNM agent version. R+B
cnm alarmqueue display Displays the alert messages waiting to be sent to the
CNM server.
R+B
cnm alarmqueue send Sends all alert messages in the queue to the CNM server
immediately and clears the queue.
R+B